Garmin G1000:Beechcraft Baron 58/G58 User Manual page 525

Garmin g1000: user guide
Hide thumbs Also See for G1000:Beechcraft Baron 58/G58:
Table of Contents

Advertisement

Normal (OBS not activated)
• Automatic sequencing of waypoints
• Manual course change on HSI not possible
• Always navigates 'TO' the active waypoint
• Must be in this mode for final approach
course
When OBS mode is active, the G1000 allows the pilot to set a desired course to/from a waypoint using the
CRS/BARO Knob and HSI (much like a VOR).
The most common application for using the OBS Softkey is the missed approach. The G1000 suspends
automatic waypoint sequencing (indicated by a 'SUSP' annunciation placed on the HSI) when the missed
approach point (MAP) is crossed. This prevents the G1000 from automatically sequencing to the missed
approach holding point (MAHP). During this time, the OBS Softkey designation changes to SUSP. Pressing
the SUSP Softkey reactivates automatic waypoint sequencing. The OBS Softkey then resumes its normal
functionality.
W
G1000
HY DOES THE
The G1000 only sequences flight plan waypoints when automatic sequencing is enabled (i.e., no "OBS" or
'SUSP' annunciation). For automatic sequencing to occur, the aircraft must also cross the "bisector" of the turn
being navigated. The bisector is a line passing through the waypoint common to two flight plan legs at an
equal angle from each leg.
H
OW CAN A WAYPOINT BE SKIPPED IN AN APPROACH
The G1000 allows the pilot to manually select any approach, departure, or arrival leg as the active leg of
the flight plan. This procedure is performed on the MFD from the Active Flight Plan Page by highlighting the
desired waypoint and selecting the ACT LEG Softkey then the ENT Key to approve the selection. The GPS
then provides navigation along the selected flight plan leg.
W
HEN DOES TURN ANTICIPATION BEGIN
The G1000 smooths adjacent leg transitions based on a normal 15° bank angle (with the ability to roll up to
30°) and provides three pilot cues for turn anticipation:
• A waypoint alert ('Next DTK ###° in # seconds' or 'Next HDG ###° in # seconds') appears on the PFD 10
seconds before the turn point and flashes as it counts down to zero.
• A flashing turn advisory ('Turn [right/left] to ###° in # seconds') appears on the PFD 10 seconds before the
turn and flashes as it counts down to zero. 'Turn [right/left] to ###° now' or 'Next [DTK/HDG] to ###° now'
is displayed when the pilot is to begin the turn and the HSI (GPS mode) automatically sequences to the next
DTK or HDG value.
• The To/From indicator on the HSI flips momentarily to indicate that the midpoint of the turn has been
crossed.
190-00663-00 Rev. A
NOT AUTOMATICALLY SEQUENCE TO THE NEXT WAYPOINT
?
Garmin G1000 Pilot's Guide for the Hawker Beechcraft C90A/GT
OBS
• Manual sequencing - 'holds' on selected
waypoint
• Manually select course to waypoint from
HSI
• Indicates 'TO' or 'FROM' waypoint
• Cannot be set for final approach course or
published holding patterns
,
,
A DEPARTURE
OR AN ARRIVAL
APPENDIX D
?
?
D-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G1000:beechcraft bonanzaG1000

Table of Contents