Garmin G1000:Beechcraft Baron 58/G58 User Manual page 279

14) As the aircraft approaches OPSHN, it may be desirable to adjust the speed, or steepness of the upcoming
descent. The default Flight Path Angle (FPA) is -3.0 degrees and a required vertical speed is computed to
maintain the -3.0 FPA. To change the vertical flight path, perform the following steps.
a) Select the VNV PROF Softkey to place the cursor in the target vertical speed field (VS TGT) as shown in Figure
5-125.
b) At this point, the descent vertical speed can be selected, or the FPA can be selected. Turn the large FMS Knob
to select the desired selection field, then turn the small FMS Knob to enter the desired value.
Note the information now displayed in the 'CURRENT VNV PROFILE' box. Also, note the offset waypoint (orange
box) and gray circle are now displayed on the map. The gray circle marks the Top of Descent (TOD). In this
example, vertical guidance is provided at the TOD that results in a -3.0 degree FPA descent to an altitude of
10,000 feet upon reaching the offset waypoint.
c) Press the ENT Key.
190-00663-00 Rev. A
Figure 5-125 Adjusting the Descent
Garmin G1000 Pilot's Guide for the Hawker Beechcraft C90A/GT
FLIGHT MANAGEMENT
5-133