Table of Contents
Advertisement
Configuring the Cisco 12012
Performing a Basic Configuration Using Configuration Mode
You can configure the Cisco 12012 system manually (via configuration mode) if you prefer
not to use the setup facility. Use the following procedure to configure the Cisco 12012
system manually:
Step 1
Step 2
Step 3
Step 4
Step 5
Your Cisco 12012 is now minimally configured and will boot with the configuration you
entered. To see a list of the configuration commands available to you, enter ? at the prompt
or press the help key while in configuration mode.
4-20 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
Connect a console terminal to the console port of your RP.
When you are asked if you want to enter the initial dialog, answer no to go into
the normal operating mode of the Cisco 12012 as follows:
Would you like to enter the initial dialog? [yes]: no
After a few seconds you will see the user EXEC prompt (
to enter enable mode. Configuration changes can only be made in enable mode:
Router> enable
The prompt will change to the privileged EXEC prompt (#) as follows:
Router#
At the enable prompt (#), enter the config terminal command to enter
configuration mode from the terminal as follows:
Router# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
At the prompt, enter the interface type slot/port command to enter interface
configuration mode as follows:
Router(config)# interface type slot/port
Router(config-if)#
In either of these configuration modes, you can enter any changes to the
Cisco 12012 configuration. Press Ctrl-Z to exit either configuration mode.
Save your settings. (Refer to the section "Saving the Running Configuration
Settings and Reviewing Your Configuration," later in this chapter.)
>). Type enable
Router
Advertisement
Table of Contents
Troubleshooting
