Figure 7-4 New Air Filter Hinge Holes And Chassis Holes Alignment - Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual

Cleaning and Replacing the Air Filter Assembly
Figure 7-4
Captive screws (2)
Hinge screws (5)
Step 3
Step 4
Step 5
Step 6
Step 7
7-10 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
New Air Filter Hinge Holes and Chassis Holes Alignment
Filter housing
Use the Number 1 Phillips screwdriver and all five of the screws you saved
earlier to fasten the bottom hinge of the new air filter tray to the chassis.
After tightening all five screws, give each screw an additional one quarter turn
to ensure a tight seal between the new air filter tray and the chassis.
Verify that the two captive screws at the top of the air filter tray are loosened.
(See Figure 7-4.)
Allow the bottom hinge to hold the air filter tray in the full open position.
Gently slide the new air filter, with the filter fabric facing downward, toward the
floor, and the open side of the filter facing upward, into the new air filter tray
until it is firmly seated against the bottom of the new air filter tray. (See
Figure 7-5.)
INPUT: ~
200 - 240V
INPUT: ~
10 A 200 - 240V
50/60 HZ INPUT: ~
10 A 200 - 240V
2000 W 50/60 HZ
10 A
2000 W 50/60 HZ
2000 W
AC
OK AC
OK AC
OK AC
OUTPUT
OK
FAIL OUTPUT
FAIL OUTPUT
FAIL OUTPUT
FAIL
INPUT: ~
200 - 240V
10 A
50/60 HZ
2000 W