Table of Contents
Advertisement
Using the diag Command
The diagnostic test command, issued at the privileged EXEC mode prompt on the system
console, takes the following form:
diag slot [halt] [previous] [mbus] [verbose] [wait] [coe]
where:
slot
halt
previous
mbus
verbose
wait
2
coe
(Continue on error)
1. Using this option results in a 15-minute delay before test results are returned. This command option is
available when using Cisco IOS Release 12.0(21)S or 12.0(21)ST, or a later release of 12.0S or 12.0ST.
2. Not recommended for use on operational, business-critical routers. This command option is available
when using Cisco IOS Release 12.0(21)S or 12.0(21)ST, or a later release of 12.0S or 12.0ST.
To stop diagnostic testing at any time, enter the halt option in the command, at the
privileged EXEC mode prompt on the system console:
diag slot halt
Specifies which card cage slot to test. The diagnostic software
determines the type of card in the slot and downloads the
appropriate tests.
(Optional) Stops the active diagnostic test.
(Optional) Allows you to examine the last test results on the card,
stored in EEPROM, specified by the slot parameter.
1
(Optional) Forces the route processor to load diags from the
mbus.
(Optional) Turns on the status messaging capability of the
diagnostics. The default is minimum messaging.
(Optional) Stops the diagnostics from reloading the Cisco IOS
image following the completion of diagnostic testing. The card
must be ejected from the slot, reinstalled in the slot, and
reconfigured manually.
(Optional) Continues testing even after a failed test.
Using the diag Command
Running Diagnostics on the Cisco 12012 6-3
Advertisement
Table of Contents
Troubleshooting
