Configuring The Cisco 12012; Performing A Basic Manual Configuration Using The Setup Facility Or The Setup Command - Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual

Configuring the Cisco 12012

Locate the Cisco IOS software image that you want to boot and boot from this image using
the following commands, as appropriate:
rommon 3> boot slot0:filename
or...
rommon 3> boot slot1:filename
or...
rommon 3> boot bootflash:filename
If you did not change the configuration register setting, the next reload will revert to the
default configuration register setting. (The factory default configuration register setting for
systems and for RP spares is 0x0102.)
Configuring the Cisco 12012
You can a complete a basic configuration of the Cisco 12012 system using one of the
procedures described in the following sections:
•
Performing a Basic Manual Configuration Using the Setup Facility or the setup
Command
•
Performing a Basic Configuration Using Configuration Mode
Follow the procedure that best fits the needs of your network configuration. You will need
to acquire the correct network addresses from your system administrator or consult your
network plan to determine correct addresses before you can complete the router
configuration.
Performing a Basic Manual Configuration Using the Setup Facility or the
setup Command
At initial startup, the Cisco 12012 defaults to the setup facility; the system automatically
goes into the setup facility. (The setup command facility functions exactly the same as a
completely unconfigured system functions when you first boot it up. You can run the setup
facility any time you are at the enable prompt (#) by entering the setup command.)
Two parameters of the system configuration are considered during setup: global parameters
and interface parameters.
4-8 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide