Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 296

Completing the Repackaging
Step 2
Step 3
Step 4
Step 5
The Cisco 12012 is now repackaged and ready to be transported. Use a forklift or pallet jack
to move the repackaged Cisco 12012.
A-10 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
Install the two wooden end panels on the pallet by performing the following
steps:
(a) Position the shipping packaging wooden end panel on the pallet so that the
two tabs on the bottom of the panel are facing out and fit into the two slots
on the pallet.
While holding the end panel, bend the two tabs outward 180 degrees with
(b)
pliers or a flat-blade screwdriver.
Repeat steps (a) and (b) for the front panel.
(c)
Secure the four sides of the shipping container together by performing the
following steps:
(a) Grasp an end panel with one hand and a side panel with the other hand and
fit the two panels together so that the six tabs on the end panel fit into the
six slots on the side panel.
(b) While holding the two panels, bend the six tabs outward 180 degrees to
secure the two panels together.
Repeat steps (a) and (b) for the remaining three sides.
(c)
Position the wooden top cap over the top of the shipping container so that the
twelve tabs on the sides of the shipping container fit into the twelve slots on the
top cap.
Bend the 12 tabs outward 180 degrees with pliers or a flat-blade screwdriver.