Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 166

Starting the System and Observing Initial Conditions
Step 6
You have the option of proceeding with the setup facility or exiting from setup and using
configuration commands to configure global (system-wide) and interface-specific
parameters. You do not have to configure the interfaces immediately; however, you cannot
4-6 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
•
b flash—Boots the first file in the Flash memory card in PCMCIA slot 0
•
b slot0: filename—Boots the file filename from the Flash memory card in
PCMCIA slot 0
•
b slot1: filename—Boots the file filename from the Flash memory card in
PCMCIA slot 1
•
b filename [host]—Boots the file filename from the server host using TFTP
After you boot a Cisco IOS software image, proceed to Step 6. (For additional
information on system boot functionality, refer to the section "Manually Booting
the System," later in this chapter.)
While the system boots from the appropriate Cisco IOS software image, the
console screen displays a script and system banner similar to the following:
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-MZ), Released Version 11.2(8)GS
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Sat 10-May-97 06:02a
Observe the system startup banner. When you start up an unconfigured system
for the first time, the system automatically enters the setup facility, which
determines which interfaces are installed and prompts you for configuration
information for each one.
On the console terminal, after the system displays the system banner and
hardware configuration, you will see the following System Configuration Dialog
prompt:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]: