Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 207

Step 2 Enter the copy startup-config slot0:filename command as follows:
Router# copy startup-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCC
Router#
In the preceding example, the exclamation points (!!!) appear as the file
Note
is copied. The "C" characters signify calculation of the checksum—a
verification that the file has been correctly copied.
You can also copy the running configuration (located in DRAM) to a Flash
memory card, as shown in the following section "Copying a Configuration File
from RP DRAM to a Flash Memory Card."
Verify the file was copied correctly using the dir command as follows:
Step 3
Router# dir slot0:
-#- -length- -----date/time------ name
1 5200084
3 1215
4 6176844
5 1186
9197156 bytes available (11381148 bytes used)
Router#
This completes the procedure for copying a configuration file between RP NVRAM and a
Flash memory card.
Observing System Startup and Performing a Basic Configuration 4-47
Implementing Other Configuration Tasks
May 10 1997 19:24:12 gsr-p-mz.112-8
May 10 1997 20:30:52 myfile1
May 10 1997 23:04:10 gsr-p-mz.112-8.1
May 10 1997 16:56:50 myfile2