Reinstalling The Cards In The Upper Card Cage - Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual

Reinstalling the Cisco 12012 Components after Installing the Frame
Step 4
Step 5
Step 6
Repeat Step 2 through Step 6 for the other blower module.

Reinstalling the Cards in the Upper Card Cage

Before you begin reinstalling cards in the upper card cage, identify slot assignments by
referring to the list you prepared when you removed the cards.
Perform the following steps to reinstall a card in the upper card cage:
Step 1
Step 2
3-26 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
Firmly push on the blower module handle to seat the module connector in the
frame connector. (When completely seated, the blower module faceplate flanges
make contact with the front of the frame.)
Note All electrical and control line connections are made automatically when
the connectors mate.
Tighten the two captive screws on the blower module faceplate.
The front covers for the top and bottom blower modules are different; the
Note
name "Cisco 12000 Series" appears at the upper left side of the top blower
module front cover. The lettering is missing from the bottom blower module
front cover.
Position the blower module front cover over the four alignment holes in the
blower module faceplate and snap the front cover onto the faceplate.
Attach an antistatic wrist strap to yourself and to one of the two ESD connection
sockets located on the front edges of the upper card cage or to bare metal on the
frame.
Select a card from the antistatic mat. Starting from slot 11 (right side of card
cage), refer to your list of occupied card slots to determine which slot the card
goes in.