Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 172

Configuring the Cisco 12012
POS3/2 unassigned
POS3/3 unassigned
ATM4/0 unassigned
(Additional displayed text omitted from this example.)
Interface IP-Address
Ethernet0 3.3.1.1
POS3/0 2.1.1.1
POS3/1 2.1.1.2
POS3/2 2.1.1.3
POS3/3 2.1.1.4
ATM4/0 1.1.1.2
(Additional displayed text omitted from this example.)
Step 4
Step 5
Step 6
4-12 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
In the following example of a yes response (during the setup command facility),
the partial summary shows a Cisco 12012 system in which some interfaces have
already been configured, and the following summary reflects this.
OK? Method Status
YES NVRAM up
YES NVRAM up
YES NVRAM up
YES NVRAM up
YES NVRAM up
YES NVRAM up
Choose which protocols to support on your interfaces. For Internet Protocol
(IP)–only installations, you can accept the default values for most of the
questions.
A typical minimal configuration using IP follows, and continues through
Step 10:
Configuring global parameters:
Enter host name [Router]: Router
Enter the enable secret password when the following is displayed, and make a
note of this password for future reference:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret [<Use current secret>]: barney
Enter the enable password when the following is displayed, and make a note of
this password for future reference:
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password: wilma
Protocol
up
up
up
up
up
up