Table of Contents
Advertisement
Use the following procedure to copy bootable Cisco IOS software images between Flash
memory cards:
Step 1
Boot the router. (For this example, the file image.boot will be used by default.)
Step 2
Enable the router as follows:
Router> en
Password:
Router#
Insert the new Flash memory card in slot 1.
Step 3
Use the following command to copy the file image.new in slot 1 to the Flash
Step 4
memory card in slot 0, only if there is enough memory space for the two images
to coexist:
Router# copy slot1:image.new slot0:image.new
You can also enter the previous command as copy slot1:image.new slot0:.
Use the following series of commands to designate the file image.new (in the
Step 5
Flash memory card in slot 0) as the default boot image:
Router# config t
Router(config)# no boot system
Router(config)# boot system flash slot0:image.new
Ctrl-z
Router# copy running-config startup-config
Router# reload
When the system reloads, it will boot the file image.new from the Flash memory card in
slot 0.
This completes the procedure for copying bootable images between Flash memory cards.
Observing System Startup and Performing a Basic Configuration 4-45
Implementing Other Configuration Tasks
Advertisement
Table of Contents
Troubleshooting
