Failed Diagnostic - Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual

Field Diag eeprom values: run 0 fail mode 0 (PASS) slot 2
Shutting down diags in slot 2
Board will reload
SLOT 2:%SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-MZ), Released Version 12.0(n)GS
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Fri 17-Sep-00 17:58 by ...
Router#
When you set the verbose option, most of the information returned by the diagnostic tests
is status messages that indicate when tests start and when they are completed. At the end of
the diagnostic tests, a message indicates whether the card passed or failed the tests.

Failed Diagnostic

If a diagnostic test fails on a line card, testing halts with that test. The line card will not
reload or come back online automatically. The following example shows a diagnostic
message stream to the console for a line card located in slot 7. In the example, the card fails
one of the diagnostic tests, stopping the diagnostic cycle on that test.
Router# diag 7 verbose
Running DIAG config check
Running Diags will halt ALL activity on the requested slot.
[confirm]
Router# <Return>
Launching a Field Diagnostic for slot 7
Downloading diagnostic tests to slot 7 (timeout set to 400 sec.)
Field Diag download COMPLETE for slot 7
FD 7> ****************************************************
FD 7> GSR Field Diagnostics V3.0
FD 7> Compiled by award on Tue Aug 3 15:58:13 PDT 2000
FD 7> view: award-bfr_112.FieldDiagRelease
FD 7> ****************************************************
FD 7> BFR_CARD_TYPE_OC48_1P_POS testing...
FD 7> running in slot 7 (128 tests)
Executing all diagnostic tests in slot 7
(total/indiv. timeout set to 600/220 sec.)
FD 7> Verbosity now (0x00000001) TESTSDISP
last test failed was 0, error code 0
Loading and Running Diagnostics
Running Diagnostics on the Cisco 12012 6-9