Selecting Endpoints To Act On; Acting On Selected Endpoints; Manually Retest An Endpoint - Extreme Networks AG200 User Manual

Endpoint Activity
NOTE
If an endpoint is seen by two different clusters, the endpoint state can get lost. This could happen, for example, if
you had a Training cluster and an Engineering cluster and a laptop that was connected in the Engineering cluster
attempted to connect by way of the Training cluster. An error would occur in this case. Make efforts when you are
configuring your clusters to avoid this condition.

Selecting Endpoints to Act on

To select endpoint to act on:
Sentriant AG Home window>>Endpoint activity
Click a box or boxes in the first column to select the endpoints of interest.
NOTE
Click the box at the top of the column to select all of the endpoints.

Acting on Selected Endpoints

Once you have filtered the Endpoint activity window and selected which endpoints to take action on,
you can perform the following actions:
Retest an endpoint ("Manually Retest an Endpoint" on page 142)
●
Allow temporary access for a specific period of time ("Immediately Grant Access to an Endpoint" on
●
page 143)
Temporarily quarantine the endpoint for a specific period of time ("Immediately Quarantine an
●
Endpoint" on page 143)
Clear the temporary quarantine or access state ("Clearing Temporary Endpoint States" on page 144)
●

Manually Retest an Endpoint

To manually retest an endpoint:
Sentriant AG Home window>>Endpoint activity
1 Select a box or boxes to select the endpoints of interest.
2 Click retest.
142
Sentriant AG Users' Guide, Version 5.0