System Configuration
port. If the Cisco device were to return 50210 for an endpoint, a port mask of 2/34 would indicate
that the endpoint is on bank 2 and port 10 (2/10), where 210 are the third, fourth and fifth bytes in
the identifier.
11 Enter the Reconnect idle time. This is the amount of time in milliseconds that a telnet/SSH console
can remain idle or unused before it is reset.
12 Select the Show scripts plus symbol to show the following scripts:
Initialization script—The expect script used to log into the console and enter enable mode.
■
Re-authentication script—The expect script used to perform endpoint re-authentication.
■
Exit script—The expect script used to exit the console.
■
13 Click ok.
NOTE
Click revert to defaults to restore the default settings.
86
Sentriant AG Users' Guide, Version 5.0