Edit Policy Endpoints Window - Extreme Networks EPICenter Software Installation Manual

The left side of this window Select Policy Access Domain Devices to be Added, displays a
component tree showing the resources currently defined in the Grouping applet.
When you select a group in the component tree, its children (groups or individual devices) are
displayed in the associated Resource list (the right half of the Select Policy Access Domain Devices
to be Added area). You can select groups or devices as access domain resources. If you select a
group that does not contain any devices as children, the group is added as an access domain
resource, but will not actually have any effect on the policy access domain.
The area on the right of the window (Current Policy Access Domain Devices) shows the resources
you have already selected to include in the access domain for your policy.
• Use the Add button to add selected resources to the Current Policy Access Domain Devices list.
• Use the Add All button to add all the children of the group you have selected in the component
tree.
• Use the Remove button to remove selected resources from the Current Policy Access Domain
Devices list.
• Use the Remove All button to remove all resources from the Current Policy Access Domain
Devices list.
• You can select the Security QoS Profile that should be configured on the device for this policy by
selecting a resource in the Current Policy Access Domain Devices list, and then selecting a
profile from the drop-down list associated with that resource.
• Click OK to close the Edit window and display the contents of the Current Policy Endpoints list
in the appropriate resource list in the Access List (Policy Traffic for IP policies) area.
• Cancel closes the Edit window and abandons any changes you've made to the Current Policy
Endpoints list.
b Use the Up and Down buttons to change the precedence of the entries in the list.
• Select an entry and click the Up button to move it up in the list (giving it higher precedence).
• Select an entry and click the Down button to move it down in the list (giving it lower
precedence).
12 To save your new policy definition, click the Save
If you attempt to leave the policy definition page without saving your new policy definition, a small
Confirm Save Policy Changes pop-up appears, asking if you want to save the changes (your new
policy).
• Click the Yes button to save the policy.
• Click No to abandon the policy
• Click Cancel to return to the Policy Definition page of the policy you were creating.
NOTE
If auto-configuration is enabled, this policy will be configured immediately on the network. This could
cause network problems if policy precedence relationships are not set correctly.

Edit Policy Endpoints Window

The Edit Policy Endpoints window, as shown in Figure 211, looks basically the same regardless of the
type of policy you are creating. The exception is the Add IP Addr and Add Any buttons that appear
only for a Security or an IP Policy endpoint. Note that these extra buttons only appear for the Network
EPICenter Software Installation and User Guide
button.
Edit Policy Endpoints Window
423