Using Video Channels Autotest; Using Cable Modem Autotest - JDS Uniphase Wavetek DSAM Series Quick Start Manual

Chapter 2 DSAM Operation
Using AutoTest Mode
Using Video
Channels
AutoTest
Using Cable
Modem
AutoTest
38
– the parameters of your limit sets, and
– your selection of a set of measurement limits (based
on test location).
The Help system offers additional instruction about these
tasks.
After a limit set has been selected, press the START
softkey and Combo AutoTest measures the signal perfor-
mance of all assigned channels in the Combo Test config-
uration.
To access Video Channels AutoTest mode, use the arrow
keys to highlight the Video Channels option on the
AutoTest mode menu
ENTER. The first Video Channels AutoTest mode screen
you see will look similar to the Combo AutoTest screen
shown in Figure
Each Video Channels AutoTest is based on three types of
configuration:
– the parameters of your limit sets,
– your selection of channels to be tested, and
– your selection of a set of measurement limits (based
on test location).
The Help system offers additional instruction about these
tasks.
After a limit set has been selected, press the START
softkey (Figure 21 on page
tially measures the signal performance of all assigned
channels in the Video Channels AutoTest configuration.
To access Cable Modem AutoTest mode, use the arrow
keys to highlight the Cable Modem option on the AutoTest
mode menu (Figure 20 on page
DSAM Product Family Quick-Start Guide Rev. G
(Figure 20 on page
21.
37) and the AutoTest sequen-
36), and press ENTER.
36), and press