Using Measure Mode; Measure Basic Menu - JDS Uniphase Wavetek DSAM Series Quick Start Manual

Chapter 2 DSAM Operation

Using Measure Mode

Using Measure Mode

Measure Basic
Menu
26
Three measurement modes are indicated by softkey tabs
at the bottom of the display screen -- Basic, Service, and
Spectrum. Each measurement mode has a menu of
measurement items specific to that mode.
To access a Basic Mode menu, press the softkey directly
below the mode you wish to view. The MEASURE BASIC
menu is displayed when you press the MEASURE mode
key for the first time. After that, the meter will display the
most recently displayed Measure mode each time you
return to the Measure menus by pressing the MEASURE
mode key.
When you have displayed the mode menu you prefer, use
the arrow keys to highlight the item you intend to configure
and press ENTER.
You are ready to perform tests in Measure mode only
when
– the meter is receiving power,
– the RF cable is connected to the meter (on the back
panel), and
– your DSAM has been configured to conduct measure-
ments (see "Configuring the Meter" on page
To view the MEASURE BASIC menu
the MEASURE mode key
press the Basic softkey. Use the arrow keys to highlight
the type of measurement you wish to perform and press
ENTER to access that option.
Here's another quick way to access Measure mode
options: Press the SHIFT key to display the options above
each softkey and press the softkey directly under the
option of your choice.
DSAM Product Family Quick-Start Guide Rev. G
(Figure
(Figure 3 on page
20).
13), press
16), then