Using Techcomplete Closeout Test - JDS Uniphase Wavetek DSAM Series Quick Start Manual

Chapter 2 DSAM Operation
Using AutoTest Mode
The first Cable Modem AutoTest mode screen you see will
look similar to the Combo AutoTest screen shown in
Figure 21 on page 37.
Cable Modem AutoTests are configured in the same
manner as Video Channels AutoTests. To perform this
test, first select
– the parameters of your limit sets,
– your selection of channels to be tested, and
– your selection of a set of measurement limits (based
on test location).
The Help system offers additional instruction about these
tasks.
After a limit set has been selected, press the START
softkey (Figure 21 on page 37) and the AutoTest sequen-
tially measures the performance of all assigned channels
in the Cable Modem AutoTest configuration.
Using
To view the AUTOTEST CLOSEOUT menu (Figure 22),
press the CLOSEOUT softkey when in Autotest mode.
TechComplete
Use the arrow keys to highlight TechComplete and press
Closeout Test
ENTER to perform this option.
DSAM Product Family Quick-Start Guide Rev. G 39