Connecting The Rf Cable; Making Additional Connections - JDS Uniphase Wavetek DSAM Series Quick Start Manual

Chapter 2 DSAM Operation
Initial Set-Up
Connecting
the RF cable
Making
additional
connections
12
Follow these three steps to connect the power compo-
nents to the DSAM battery (the battery can be in or out of
the meter):
1 Align the tabs of the charger module connector to the
slots in the battery and gently insert the connector
tabs into the battery slots.
2 Align the universal power supply module connector
(or DC connector) with the DC connection port in the
charger module and gently insert the connector into
the connection port.
3 Align the power cord connector with the universal
power supply connection port and gently insert the
connector into the connection port. Connect the
power cord plug to an AC power source when you are
ready to power the meter or charge the battery. (If you
are using the DC connector, connect it to an appro-
priate 12-volt DC power source.)
To conduct measurements with your DSAM, connect the
RF cable of the system you are servicing to the RF
connection port on the back panel of the meter.
Use the Ethernet port located on the top of the meter to
clone settings with other DSAM meters (see
DSAM Meters" on page
with optional FDM utility software (see
Mode" on page 41).
(The headphone jack and USB ports located on the top of
the meter will be used in future DSAM applications.)
DSAM Product Family Quick-Start Guide Rev. G
43) or to synchronize your data
"Using Access
"Cloning