Table of Contents
Advertisement
Using Measure Mode
Basic Menu
DSAM Product Family Quick-Start Guide Rev. 001
Measurement modes are indicated by softkey tabs at the
bottom of the display screen – Basic, Service, Spectrum
and Sweep. Each measurement mode has a menu of
measurement items specific to that mode.
To access a Measure Mode menu, press the softkey
directly below the mode you wish to view. The Measure
Basic menu is displayed when you press the Measure
mode key for the first time. After that, the meter will display
the most recently displayed Measure mode each time you
return to the Measure menus by pressing the Measure
mode key.
When you have displayed the mode menu you prefer, use
the arrow keys to highlight the item you intend to configure
and press Enter.
You are ready to perform tests in Measure mode only
when:
– The meter is receiving power
– The RF cable is connected to the meter (on the back
panel)
– Your DSAM meter has been configured to conduct
measurements (see
page
23)
To view the Measure Basic menu
press the Measure mode key
press the Basic softkey. Use the arrow keys to highlight
the type of measurement you wish to perform and press
Enter to access that option.
Chapter 2 DSAM Meter Operation
Using Measure Mode
"Configuring the Meter" on
(Figure 15 on page
(Figure 5 on page
30),
18), then
29
Advertisement
Table of Contents
