Mechatrolink-Ii Inverter F7 And G7 - Omron TJ1-DRT Hardware Reference Manual

Hardware reference
To use the V7 inverter with the MECHATROLINK-II interface it is
necessary to make the following settings in the inverter:
• N3=3 Sequence via MECHATROLINK-II
• N4=9 Reference via MECHATROLINK-II
Check the manual for details about the V7 inverter.
3.5.9

MECHATROLINK-II Inverter F7 and G7

The illustration shows the installation of the SI-T card.
A. SI-T Card
B. Control terminal
C. 3CN: Option D connector
D. Option CN (To secure option C or D)
E. 2CN: Option C connector
F. 4CN: Option A connector
HARDWARE REFERENCE MANUAL
fig. 51
F
E
D
C
B
A
102