Page 1
48 x 96 mm CompoBus/D E5EK-AA2-DRT Note: 1. The heater burnout alarm function can be used only when an ON/OFF Output Unit is used for the control outputs (heat). 2. Be sure to specify the Current Transformer and Output Unit when ordering. Description...
Page 2
Outer diameter: 11.6 mm Length: 100 m Terminal Block Terminating Resistor DRS1-T Resistance: Note: Refer to CompoBus/D Operation Manual (W267) and CompoBus/D Catalog (Q102) for details such as ratings and characteristics. Ranges Platinum Resistance Thermometer Input (switch selectable) JPt100 Pt100 Range –199.9 to 650.0...
Option Run/Stop selection, etc. Note: 1. To conform to EN50081-2 (FCC Class A) for ratings of noise terminal voltages, attach a noise filter (TDK ZCB2206-11 or equivalent) to the AC power supply line. 2. Fuzzy self-tuning is not provided with the E5EK-DRT.
Page 4
Note: 1. The indication accuracy of the K, T, and N thermocouples at a temperature of -100 C or less is 2 C 1 digit maximum. The indication accuracy of the B thermocouple at a temperature of 400 C or less is unrestricted.
Page 5
Note: 1. Use the K2CU-FjjA-jGS (with gate input terminals) for the detection of three-phase heater burnout. 2. The heater burnout alarm is always OFF if the alarm is set to 0.0 A and always ON if the alarm is set to 50.0 A.
1 0 to 10 V Platinum resistance Auxiliary Thermo- thermometer output 2 couple 4 to 20 mA, 0 to 20 mA Precautions For application precautions, refer to the CompoBus/D Operation Manual (W267) and E5EK CompoBus/D-type Digital Controller Operation Manual (H99).
Page 8
E5EK-DRT E5EK-DRT ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. H98-E1-1 In the interest of product improvement, specifications are subject to change without notice.