Viewing The Host Serf Summary - ADC FlexWave Prism System Reference Manual

•
Over Temperature
temperature of the Host is above its operating limits. Fault threshold is
•
Primary Clock Priority Fault
system that has the same Clock Priority Level (CPL) as this Host. All Hosts that are
in conflict generate this alarm. When all Hosts with this alarm are provisioned
with unique CPLs, the alarm clears. Service is disrupted on all systems when this
alarm is present. The
•
Under Temperature Fault
temperature of the Host is below its operating limits. Fault threshold is
•
Secondary Clock Priority Fault
Priority Level for the Host managing the Remote has been changed. All Hosts in
the system generate this alarm. When all Hosts with this alarm are provisioned
with unique CPLs, the alarm clears. Service is not disrupted, but could become
disrupted if the host providing the clock becomes unavailable. The
is a Minor alarm.
Priority Fault
•
Host Temperature Measurement
degrees Centigrade detected by the Host.
For corrective actions for alarm states, refer to
page 264. For information on setting the Clock Priority Level, see
Priority Level" on page
FlexWave Prism Host, Remote and EMS 5.1 System Reference
ADCP-77-073 • Issue 2 • 11/2009
—Red indicates
Fault
—Indicates that there is another Host in a Multi-Host
Primary Clock Priority Fault
—Yellow indicates that the current chassis-internal
—In a three-Host system, indicates that the Clock
—Gives the current chassis-internal temperature in
150.

Viewing the Host SeRF Summary

that the current
is a Major alarm.
"Troubleshooting Alarms" on
© 2009 ADC Telecommunications, Inc.
CORNING EX1005, page 237
chassis-internal
.
90° C
.
-40° C
Secondary Clock
"Set the Clock
Page 223
IPR2021-00762