Mounting To A Control Panel - Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual

Screw-less Clamp Terminals
Dimensions
5-7-9

Mounting to a Control Panel

Mounting to a DIN
Track
Note 1. The I/O power supply's right-side and left-side V terminals, and the right-
side and left-side G terminals, are not connected internally. Supply power
separately between V and G on the right and left sides respectively.
2. When using inductive loads (such as solenoid valves), use a load with a
built-in diode to absorb reverse power or attach a diode externally
3. Wire colors have been changed according to revisions in the JIS standards
for photoelectric and proximity sensors. The colors in parentheses are the
wire colors prior to the revisions.
A Remote I/O Terminal (either a Basic Unit or Expansion Unit) can be
mounted to a control panel as shown below.
Mount a 35-mm DIN Track to the rear panel of the Slave. Firmly insert the
Slave into the DIN Track while pulling down the DIN Track mounting hooks on
the rear panel with a screwdriver. Secure the Slave on the right and left sides
between a pair of end plates.
245
Section 5-7
231