Installation
3-2-1
Installing the DeviceNet Communications Unit and Temperature
Controllers
1,2,3...
3-2-2
Mounting to DIN Rail
Mounting Bracket
28
1. Align the connectors and connect the Units to each other.
DeviceNet Communications Unit
Connect the End Unit to the right end and connect the DeviceNet Commu-
nications Unit to the left end.
2. Slide the yellow sliders on the top and bottom of the Units until they click
into place.
Slider
3. Attach the cover seal to the connector on the Unit on the left end of the
EJ1.
Seal
Mount the DeviceNet Communications Unit and Temperature Controllers to
the DIN Rail.
Use screws to attach the DIN Rail to the control panel in at least three places.
Temperature Controller
EDU
Lock
Section 3-2