Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 382

Analog Output Terminals
Output Range Settings
Setting Using the
DeviceNet Configurator
1,2,3...
■ Output 0
Signal range
0 to 5 V
1 to 5 V
0 to 10 V
–10 to 10 V
4 to 20 mA
0 to 20 mA
■ Output 1
Signal range
0 to 5 V
1 to 5 V
0 to 10 V
–10 to 10 V
4 to 20 mA
0 to 20 mA
Use the following procedure to set the output range for each output using the
Configurator.
1. Double-click the icon of the Slave to be set in the Main Window and open
the Edit Device Parameters Window. (From the Maintenance Mode Win-
dow, click the right mouse button over the Slave icon and select Parame-
ters and Edit.)
2. Select the Tab Page for the output where the range is to be changed.
3. Click the Output Range field, and select the desired range.
4. Return to the General Tab, click the Download Button, and then click the
Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
Pin 1
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
Pin 4
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
Section 7-5
Pin 2 Pin 3
OFF
OFF
OFF
OFF
ON
ON
Pin 5 Pin 6
OFF
OFF
OFF
OFF
ON
ON
361