Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 221

Devicenet slaves
Hide thumbs Also See for DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008:
Table of Contents

Advertisement

Connector Terminals with Transistors
Connecting to I/O Terminals Using OMRON MIL Cables
Slave
DRT2-ID32B
G79-I50-25-D1 (50 cm)
G79-I75-50-D1 (75 cm)
DRT2-OD32B
G79-O50-25-D1 (50 cm)
G79-O75-50-D1 (75 cm)
DRT2-MD32B
G79-M50-25-D1 (50 cm)
G79-M75-50-D1 (75 cm)
DRT2-ID32B-1
G79-I50-25-D2 (50 cm)
G79-I75-50-D2 (75 cm)
DRT2-OD32B-1
G79-O50-25-D1 (50 cm)
G79-O75-50-D1 (75 cm)
G79-I50-25-D1 (50 cm)
G79-I75-50-D1 (75 cm)
DRT2-MD32B-1
G79-M50-25-D2 (50 cm)
G79-M75-50-D2 (75 cm)
200
The MIL Cables listed in the following table are available to connect OMRON
I/O Terminals (e.g., I/O Relay Blocks). Select the MIL Cable that matches the
Remote I/O Terminal and the I/O Terminal.
MIL Cable
I/O Relay Block or other I/O
G7TC-ID16
G7TC-IA16
G7TC-OC08/OC16
G70D-SOC16/VSOC16
G70A-ZOC16-3
G70D-FOM16/VFOM16
Inputs: G7TC-ID16/IA16
Outputs: G7TC-OC08/OC16
G70A-ZIM16-5
G70A-ZOC16-4
G70D-SOC16-1
G7TC-OC16-4
M7F
Inputs: G70A-ZIM16-5
Outputs: G70A-ZOC16-4
The following cables are also available with a MIL connector on the Remote
I/O Terminal end and loose wires on the other end.
MIL Cable
G79-A200C-D1 (2 m)
G79-A500C-D1 (5 m)
G79-Y100C-D1 (1 m)
G79-Y200C-D1 (2 m)
G79-Y500C-D1 (5 m)
Terminal
G70D-SOC16/VSOC16
G70A-ZOC16-3
G70D-SOC16-1
Remarks
Loose wire size: AWG28
Loose wires are cut.
Forked terminals are attached to the loose wires.
Forked terminals: 161071-M2 (Nippon Terminal)
Section 5-6
Remarks
---
---
I/O are distinguished by color.
Input tube color: Red
Output tube color: Yellow
---
---
---
I/O are distinguished by color.
Input tube color: Red
Output tube color: Yellow

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Devicenet drt2-id08Devicenet drt2-id08-1Devicenet drt2-id16-1Devicenet drt2-od16Devicenet drt2-od08Devicenet drt2-md16 ... Show all

Table of Contents