Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 203

Connector Terminals with Transistors
Using Pressure-
welded Flat Cable
Connectors
1,2,3...
182
The following cables are also available with a MIL connector on the Remote
I/O Terminal end and loose wires on the other end.
MIL Cable
G79-A200C-D1 (2 m)
G79-A500C-D1 (5 m)
G79-Y100C-D1 (1 m)
G79-Y200C-D1 (2 m)
G79-Y500C-D1 (5 m)
The MIL pin numbers, loose wire colors, dot markings, and dot colors are
listed in the following table.
Pin Core Dot
No. color marking
■
1 Light
brown
2
3 Yellow
4
5 Light
green
6
7 Gray
8
9 White
10
■ ■
11 Light
brown
12
13 Yellow
14
15 Light
green
16
17 Gray
18
19 White
20
Use the following procedure to prepare flat cables with XG4M-4030-T MIL
Connectors.
1. Use precision screwdrivers to open the hooks on both ends and separate
the contacts from the cover of the MIL socket. There are two tabs on each
end of the contact side of the socket. Release both of these at the same
time, not one at a time.
2. Place the flat cable between the contacts and cover of the socket, align the
contacts, and press on the cover to lock it in place on the contacts. Use a
Remarks
Loose wire size: AWG28
Loose wires are cut.
Forked terminals are attached to the loose wires.
Forked terminals: 161071-M2 (Nippon Terminal)
Dot color Pin Core
No. color
Black 21 Light
brown
Red 22
Black 23 Yellow
Red 24
Black 25 Light
green
Red 26
Black 27 Gray
Red 28
Black 29 White
Red 30
Black 31 Light
brown
Red 32
Black 33 Yellow
Red 34
Black 35 Light
green
Red 36
Black 37 Gray
Red 38
Black 39 White
Red 40
Section 5-6
Dot Dot color
marking
■ ■ ■
Black
Red
Black
Red
Black
Red
Black
Red
Black
Red
■ ■ ■ ■
Black
Red
Black
Red
Black
Red
Black
Red
Black
Red