Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 330

Common Procedures
Baud Rate Setting
7-2-3 Mounting in Control Panels
Using DIN Track
Connecting End Plates
Mounting Direction
2. The following window will be displayed. Enter the node address.
3. Click the OK Button.
Note Any node address within the setting range can be used as long as it is not
already set for another node. Setting the same node address for more than
one node will cause a node address duplication error and communications will
not start.
The baud rate of the system is determined by the baud rate set for the Master
Unit (automatic detection). Setting the baud rate for each Unit is not required.
An Analog Slave can be mounted in a control panel using the following
method.
Mount the back of the Slave to a 35-mm DIN Track. To mount the Slave, pull
down on the mounting hook on the back of the Unit with a screwdriver, latch
the DIN Track onto the back of the Slave, and then secure the Slave to the
DIN Track. Secure the Slaves by mounting End Plates on both sides of them.
Hook the bottom of the End Plates onto the DIN Track, as shown at (1) in the
following diagram, then hook the top of the End Plates as shown at (2).
Note Always attach End Plates to both ends of Slaves connected to the DIN Track.
Unless specific restrictions are given for the Slave, it can be mounted in any of
the following six directions. The input accuracy of the DRT2-TS04T depends
on the mounting method in some cases (see note).
Note The input accuracy of a DRT2-TS04T is slightly less accurate if mounted ver-
tically or facing down (mounting direction 3, 4, or 6 below) when the
DRT2-TS04T is used to replace another Temperature Input Terminal and the
existing Terminal Block is left in place. For details, refer to the Performance
2
1
End plate
Section 7-2
309