Table of Contents
Advertisement
Chapter 6. Adjustment of Instructions
6-1. Adjustment of Pressure
The adjustment of pressure is determined as following drawing plus the table above:
a. The pressure value must be set to "0" after work, to avoid incorrect pressure for next job, incorrect
pressure may cause danger.
b. Returning to "0" after job will ensure the accuracy of pressure for next operation.
c. Pressure value shall be set according to the table above, too small pressure will affect efficiency and
increase the wearing of machine and saw blade, while too big pressure will likely damage the saw blade,
parts and machine.
32
Advertisement
Table of Contents
Need help?
Do you have a question about the KP-200 and is the answer not in the manual?