Table of Contents
Advertisement
Stand Mode Off Time
This feature specifies the amount of time reader illumination stays off after pulling the trigger when in Stand
Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16 seconds).
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield two digits. For example: 2 = 02, 5 = 05, 20 = 20, etc.
3. Go to
page 73
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: Set Stand Mode Illuminator Off Time.
5. Scan the appropriate two digits from the keypad in
was determined in the steps above. You will hear a two-beep indication after the last character.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 38. Stand Mode Off Time
STEP
ACTION
1
Desired Setting
2
Pad leading zero
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Appendix D,
Table 38
for some examples of how to set this feature.
500 ms
01
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT STAND MODE OFF TIME
'0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Keypad, that represent the setting which
EXAMPLES
1 Second
5.5 Seconds
02
11
'0' and '2'
'1' and '1'
Scanning Features
16 Seconds
32
'3' and '2'
229
Advertisement
Table of Contents
