Additional Features For 16-Key Models; Last Code Shown Timeout - Datalogic PowerScan 9100 Series Product Reference Manual

Enter/Exit Programming Mode

ADDITIONAL FEATURES FOR 16-KEY MODELS

See also

Last Code Shown Timeout

After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT).
The standard DISPLAY OFF TIMEOUT (see
LAST CODE SHOWN TOUT, so the two parameters should be combined to get the desired
result.
Last Code Shown Timeout
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
268
Function Keys Configuration (16-key models only) on page
page 253
) has a higher priority than the
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 2 digits (00-63 by 01) from the
Alphanumeric characters in
End by scanning the ENTER/EXIT bar code twice.
CANCEL
PowerScan™ PD9130/PBT9100/PM9100
263.
.
Appendix D, Keypad.