Conductor Routing And Grounding - Toshiba G9 Installation And Operation Manual

efesotomasyon.com -Toshiba inverter,drive,servo,plc

Conductor Routing and Grounding

• Use separate metal conduits for routing the input power, output power, and control circuits.
• A separate ground cable shall be run inside of the conduit of the input power, output power, and the
control circuits.
• A separate ground cable should be run inside the conduit with the input power, output power, and
and control circuits.
• DO NOT connect CC to earth ground.
• Use IICC terminal as the return for the VI/II (V/I) input.
• Always ground the unit to prevent electrical shock and to help reduce electrical noise.
• It is the responsibility of the ASD Installer/Maintenance personnel to provide proper grounding and
branch circuit protection in accordance with the 2008 NEC and any applicable local codes.
— T h e M e t a l O f C o n d u i t I s N o t A n A c c e p t a b l e G r o u n d —
Grounding Capacitor Switch
The ASD is equipped with noise reduction capacitors which are used to reduce the EMI leakage via the
3-phase power-input circuit and for compliance with the Electromagnetic Compatibility Directive
(EMC).
The effective value of the capacitor may be increased, reduced, or removed entirely via the Selector
Switch, Switching Bar, or the Switching Screw — the type used is typeform-specific.
The Grounding Capacitor Switch allows the user to quickly change the value of the leakage-reduction
capacitance of the 3-phase input circuit without the use of tools.
See the section titled
See figures 4, 5, 6, and
the Grounding Capacitor
G9 ASD Installation and Operation Manual
WARNING
System Grounding on pg. 18 for more on the
7 on pg. 19 for an electrical depiction of the leakage-reduction functionality of
and the methods used to set the capacitance value.
Grounding Capacitor.
5