Toshiba G9 Installation And Operation Manual page 188

efesotomasyon.com -Toshiba inverter,drive,servo,plc
F561
Preset Speed 1 Operation Mode
Program Pattern Run Operation Mode
This parameter is enabled at F560
direction of Preset Speed 1.
This screen is comprised of 4 fields and are labeled as follows: Direction, Acc/
Dec Group, V/f Group, and Torque Limit Group. Scroll to the field of
interest and press the scroll knob (Enter). Using the scroll knob, set the value
and press the scroll knob (Enter).
Parameters F562 – F575 are used to set the functions listed here for Preset
Speeds 2 – 15.
When using communications write the appropriate byte to location
indicated below.
Settings:
0 — Forward Run
1 — Reverse Run
2 — Accel/Decel Switching 1
4 — Accel/Decel Switching 2
8 — V/f Switching Signal 1
16 — V/f Switching Signal 2
32 — Torque Limit Switching Signal 1
64 — Torque Limit Switching Signal 2
Writing the following data to location
Forward Run, A/D SW 2, V/f SW 3, Torque Lim SW 4.
Torque Limit
V/f Switch
Switch 2
1 1
1
64 32 16
00=T-Lim 1
01=T-Lim 2
10=T-Lim 3
11=T-Lim 4
Preset Speed 2 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Preset Speed 3 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
180
and is used to set the speed, torque, and
F561
F561 via communications results in:
A/D Switch F/R
0 1 0
0
8 4 2
1
0=F
1=R
00=A/D 1
00=V/f 1
01=V/f 2 01=A/D 2
10=V/f 3 10=A/D 3
11=V/f 4 11=A/D 4
Direct Access Number — F561
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
as
Direct Access Number — F562
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Direct Access Number — F563
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
G9 ASD Installation and Operation Manual
F563