Toshiba G9 Installation And Operation Manual page 222

efesotomasyon.com -Toshiba inverter,drive,servo,plc
F902
Input Function Target 2
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Input Function Target 2
terminal.
This setting assigns the function of the programmable Input Function Target
2 terminal to any one of the user-selectable functions listed in
238, Table 8 on pg. 239, or Table 10 on pg.
See F977 for more information on this parameter.
Input Function Command 2
Program My Function My Function Unit 1
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 11 on pg. 243 lists the available selections. Their use and selection
requirements are described in an example at F977.
Input Function Target 3
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Input Function Target 3
terminal.
This setting assigns the function of the programmable Input Function Target
3 terminal to any one of the user-selectable functions listed in
238, Table 8 on pg. 239, or Table 10 on pg.
See F977 for more information on this parameter.
Output Function Assigned
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the Output Function Assigned terminal.
This setting assigns the function of the programmable Output Function
Assigned data location to one of the functions listed in the Input Setting field
of Table 7 on pg. 238.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and
information on this parameter.
214
Table 7 on pg.
241.
Table 7 on pg.
241.
F977 for more
F905
Direct Access Number — F902
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Direct Access Number — F903
Parameter Type — Selection List
Factory Default — 0 (NOP)
Direct Access Number — F904
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Direct Access Number — F905
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
G9 ASD Installation and Operation Manual