9.4.7
Replacing pedelec components if
lock function is installed
9.4.7.1 Replacing a smartphone
1 Install Bosch eBike connect app on the new
smartphone.
2 Log on using the same account which was
used to activate the lock function.
3 Connect on-board computer with the
smartphone while the on-board computer is in
use.
The lock function is shown as set up in the
BOSCH eBike Connect app.
9.4.7.2 Replacing the on-board computer
Connect on-board computer with the
smartphone while the on-board computer is in
use.
The lock function is shown as set up in the
BOSCH eBike Connect app.
9.4.7.3 Activating the lock function after motor
replacement
The lock function is displayed as deactivated in
the eBike Connect app when the motor has been
replaced.
1 Open the <My eBike> menu item in the eBike
Connect app.
2 Push the <Lock function> slider to the right.
The drive unit assistance can now be
deactivated by removing the on-board
computer.
MY23I0a - 42_1.0_22.01.2024
Troubleshooting, fault clearance and repair
266
Need help?
Do you have a question about the i:SY E5 ZR F CX and is the answer not in the manual?