Replacing Pedelec Components If Lock Function Is Installed; Replacing A Smartphone; Replacing The On-Board Computer; Activating The Lock Function After Motor Replacement - Bosch Intuvia 100 Translation Of Original Operating Instructions

9.4.7 Replacing pedelec components if
lock function is installed

9.4.7.1 Replacing a smartphone

1 Install Bosch eBike connect app on the new
smartphone.
2 Log on using the same account which was
used to activate the lock function.
3 Connect on-board computer with the
smartphone while the on-board computer is in
use.
 The lock function is shown as set up in the
BOSCH eBike Connect app.

9.4.7.2 Replacing the on-board computer

 Connect on-board computer with the
smartphone while the on-board computer is in
use.
 The lock function is shown as set up in the
BOSCH eBike Connect app.
9.4.7.3 Activating the lock function after motor
replacement
The lock function is displayed as deactivated in

the eBike Connect app when the motor has been
replaced.
1 Open the <My eBike> menu item in the eBike
Connect app.
2 Push the <Lock function> slider to the right.
 The drive unit assistance can now be
deactivated by removing the on-board
computer.
MY23P0a -52_1.0_11.10.2022
Troubleshooting, fault clearance and repair
273