Table of Contents
Advertisement
6.4.9.8 Setting the grip distance on a TEKTRO handbrake
Only applies to pedelecs with this equipment
Notice
If the setting screw is fully removed, components
inside the handbrake will also be permanently
twisted off as well. The handbrake will be
permanently damaged.
Never completely remove setting screws.
Figure 127: Setting screw position (1)
MY23I0a - 42_1.0_22.01.2024
The handbrake position can be adjusted to the
rider's requirements.
Undo 2 mm setting screw anti-clockwise.
The handbrake will move closer to the
handlebar grip.
Turn 2 mm setting screw clockwise.
The handbrake will move away from the
handlebar grip.
This adjustment affects the position of the
brake linings.
Re-adjust the brake linings after adjustment.
Operation
133
Advertisement
Table of Contents
