Braking; Emergency Braking; Normal Braking - Fayat Group DYNAPAC CA25 Instruction Manual

2
Fig. Control panel:
2. Emergency stop;
Fig. Control panel:
3. Vibration switch;
5. Forward/reverse lever;
10-03-2022
Operation – Stopping

Braking

Emergency braking

Braking is normally activated using the forward/reverse
lever. The hydrostatic transmission brakes the machine
when the lever is moved to the neutral position.
There is also a brake in the Drum motor and rear axle of
the machine that acts as an emergency brake during
operation.
For emergency braking, press the respective
button (2), hold the steering wheel firmly and be
prepared for a sudden stop. The brakes are
applied and the engine stops.
After emergency braking, return the forward/reverse lever
to neutral position and pull out the button (2). If the machine
is fitted with a locking function, it is necessary to sit down
in the operator's seat to restart the engine.

Normal braking

Press the switch (3) to switch off the vibration.
Place the forward/reverse lever (5) to neutral position to
stop the machine.
Set Throttle control to idle running position.
Set the parking brake switch in the 'ON' position.
3
Always use the parking brake when the machine
5
is stationary on a sloping surface.
When starting and driving a machine that is
cold, remember that the hydraulic fluid is also
cold and that braking distances can be longer
than normal until the machine reaches the
working temperature.
4812330982EN
Operation – Stopping
65