Calibrating The Scanner At The Document Feeder - Xerox Phaser 8560MFP User Manual

Calibrating the Scanner at the Document Feeder

To calibrate the scanner at the document feeder:
1. Place the Scanner Calibration page in the document feeder, so that the top edge of the
page enters the feeder first. Adjust the paper guides to fit against the page.
Note:
Make sure the Scanner Calibration page is aligned correctly and the paper guides
are adjusted to fit against the paper. If the page is misaligned, the calibration procedure
will fail.
2. On the control panel, select
scan the calibration page.
3. Wait for the scan to be completed, and then select one of the following options:
■ If the control panel indicates
procedure is complete.
■ If the control panel indicates
Note:
For more information about calibrating the scanner, see the Knowledge Base at
www.xerox.com/office/8510_8560support.
Phaser® 8510/8560MFP Multifunction Product
Document Feeder Step
Success , press the OK button. The calibration
, press the OK button, and then repeat Steps 1–3.
Failure
5-37
Calibrating the Scanner
LTR/LGL
, and then press the OK button to