Xerox Phaser 8560MFP User Manual page 105

Erasing the Edges of Copy Documents
You can clean the edges of your copies, eliminating unwanted material from printing, by
specifying the amount to erase on the right, left, top, and/or bottom edge.
To erase edges on copies:
1. On the control panel, press the Copy button.
2. Select , and then press the OK button.
Edge Erase
3.
To erase the left edge:
a. Select , and then press the OK button.
Left
b. Select a number from
through mm (in 1 mm increments), and then press the OK button.
25
4. To erase the right edge:
a. Select , and then press the OK button.
Right
b. Select a number from
through mm (in 1 mm increments), and then press the OK button.
25
5. To erase the top edge:
a. Select , and then press the OK button.
Top
b.
Select a number from
through 25 mm (in 1 mm increments), and then press the OK button.
6.
To erase the bottom edge:
a.
Select Bottom , and then press the OK button.
b. Select a number from
through mm (in 1 mm increments), and then press the OK button.
25
When you select
Edge Erase
right side of the control panel display.
Note: The factory default is Off (edge erase of 0 on all sides).
Phaser® 8510/8560MFP Multifunction Product
through inches (in 0.1 inch increments) or from
0.0 1.0
through inches (in 0.1 inch increments) or from
0.0 1.0
through inches (in 0.1 inch increments) or from
0.0 1.0
through inches (in 0.1 inch increments) or from
0.0 1.0
, a page icon displaying the edge erase setting appears on the
4-12
Adjusting Copying Options
0
0
0
0