How Remove Wheel - Bay-Tek Big Bass Wheel Service Manual

HOW TO REMOVE WHEEL
The large wheel may have to be removed from the cabinet to replace certain parts of the wheel assembly.
The entire wheel can be slid out the back of the game on wooden rails. The drive chain will come out with
the wheel.
Instructions:
1.) turn off the game at the power strip and unplug it from the wall outlet.
2.) Remove the back door and set it aside.
3.) Remove the upper and lower back cabinet wood pieces. Unplug and remove the line filter in the bottom
wood piece. Save the hardware for later installation.
4.) Use a 7/16" socket to loosen the motor bracket from the side of the cabinet. Take the chain off the gear
and let it fall to the bottom of the game. It will slide out with the wheel. Unplug and remove the motor brack-
et. Save the hardware for later installation.
5.) Open the left side door and unplug the encoder sensor and remove the bracket/sensor using a 7/16"
wrench. Save the hardware for later installation.
6.) Remove the brake assembly using a 7/16" wrench. Save the hardware for later installation.
7.) Open the right side door and unplug the solenoid assembly at the door hinge.
You must also remove the wood block holding the wire to the side of the cabinet.
Use a 7/16" wrench to remove this wood block. Save the hardware for later installa-
tion.
8.) Remove the cotter pin holding the long pull arm coming from the front of the
game.
9.) On both sides of the wheel, there are mounting plates that attach the wheel to the
side of the cabinet. Use a 7/16: wrench to remove the 2 bolts in each plate. Save the
hardware for later installation.
10.) Using 2 people , carefully slide the wheel out from the back and set it on a soft sur-
face to avoid possible damage to the decals.
11.) The components on the center wheel shaft can now be removed and replaced if needed.
47