Troubleshooting Guide - Bay-Tek Big Bass Wheel Service Manual

TROUBLESHOOTING GUIDE

Troubleshooting Strategy
Use common sense and a systematic method of troubleshooting to determine the exact problem, probable cause and
remedy. Use the process of elimination to find the faulty component. Always check for the simple and obvious causes
first such as unplugged, loose or broken wires and bad sensors, bent, pinched, stuck or jammed components.
Problem
No power to the game
No lights on at all
Monitor is on
But everything else off
(Power Supply not ON)
Dollar Bill Acceptor not
functioning
Ensure Bill Acceptor is set to
"Always Enable"
110 VAC
Part # A5AC9101
Check settings in
menu.
Very
Soft or
Very
Loud
Software/
Audio
Motherboard
differences
Troubleshooting Chart
Probable Cause
Unplugged.
Power strip turned off,
or plugs unplugged.
Circuit breaker tripped.
Line filter faulty.
Bad or overloaded power
supply.
Power supply unplugged.
Rocker Switch on power
supply is Off.
Power supply shutting
down because of 12 V
overload.
Faulty power supply.
Check for power to Bill
Acceptor.
Dirt or debris in acceptor
slot.
Pinched, broken, or
disconnected wiring.
Bill acceptor problem.
Part # A5AC9094
Increase the volume by pressing Menu
button, scroll to volume slider bar and
adjust.
Refer to "Keyboard/Mouse Adjusting of Master Volume"
29
Check wall outlet cable (A5CORD5) to line filter
in back of game. (A5FI9010)
Check rocker switch on power strip. Ensure
power cords are pushed into power strip
securely
Reset power strip breaker switch or building
circuit breaker. Attempt to determine cause.
Replace line filter. (A5FI9010)
Refer to Power Supply Diagnostics
If the supply cord is damaged, it must be replaced by
a special cord or assembly available from the
manufacturer or its service agent.
Insure power supply is plugged into
power strip.
Make sure rocker switch is set ON.
See power supply diagnostics to isolate bad
component. A bad solenoid or 12 volt short
would cause this.
Refer to Power Supply Diagnostics section.
Acceptor should cycle stacker at game
power up. If not, check cable connections.
Refer to "How to Clean Bill Acceptor" Or clean
with bill reader cleaning card. (A5CC9000)
Check wiring from bill acceptor to I/O Aux
Board. (AACE16019) Repair or
replace wiring harness. Make sure wires are
secure in connectors.
Refer to troubleshooting section of dollar bill
acceptor manual included with this game or
the diagnostics label of the back of the unit.
Remedy