How To Jump Start Motherboard - Bay-Tek Big Bass Wheel Service Manual

HOW TO "JUMP START" MOTHERBOARD
Symptom: The game is turned ON, but the power supply is not running.
(The fan on the power supply is not turning with no lights on cabinet.)
If the green LED on the motherboard is ON, then the motherboard itself is turned off.
This could happen with a power surge or AC voltage dip.
With the motherboard installed, and game powered on, there will be a green LED on the motherboard.
There are 9 pins in the corner of the motherboard near the battery. They have different colored bases. (Red,
green, orange, blue)
Use a metal screwdriver and touch the 2 red pins at the same time to create a momentary short.
It is like an ON switch for a computer.
Touch the 2 red pins and then remove right away. The fan on the motherboard should start turning and the
game should come on.
Note: The location of this connector may vary
depending on which version motherboard is in
game.
AAMB7 Version
Motherboard
To prevent having to do this repeatable to the board, consider purchasing a small plug-in connector to do this automat-
ically:
Part # AACA1320-R
Newer motherboards already have this capacitor installed and this should not be an issue.
48
Motherboard "Jump Start"
If green Led is ON, but fan
not turning, you may start
motherboard by quickly
touching these 2 red pins at
the same time. If fan starts
turning, motherboard will turn
ON and boot normally.