Bay-Tek Big Bass Wheel Service Manual page 8

BIG BASS WHEEL GAME SETUP
USING TWO PEOPLE, PLACE THE MONITOR UNIT
ON TOP OF THE GAME CABINET.
THERE ARE HOLES ON THE UNIT THAT WILL LINE
UP WITH HOLES ON TOP OF THE GAME CABINET.
PLUG IN THE MONITOR POWER CABLE AND VGA SIGNAAL CABLE.
SECURE THE SLACK IN THE CABLE CLAMPS.
PLUG IN THE BLACK PHONE CABLE TO THE SPLITTER BOARD
USE THE BOLTS PROVIDED TO MOUNT THE MONITOR
UNIT TO THE CABINET.
USE A 7/16" SOCKET.
USING TWO PEOPLE, SET THE FISH HEAD ON THE GAME.
THE FRONT END OF THE FISH WILL HANG OVER THE MONITOR
IF YOU CHOOSE TO USE THE BOBBER ASSEMBLY, RUN THE PIPE
AND CABLES DOWN THROUGH THE FISH HEAD.
THE PIPE WILL FIT IN THIS WOODEN HOLDER BEHIND THE MONITOR.
PLUG BOTH BLACK PHONECABLES FROM BOBBER TO THE SPLITTER BOARD.
IT DOES NOT MATTER WHICH PLUG GOES INTO WHICH SOCKET.
PLUG GREY PHONE CABLE INTO RED AND BLACK CABLE TO PROVIDE 12
INTO A WOODEN HOLDER.
VOLTS TO BOBBER
8