Bill Acceptor Diagnostics; Available Blanking Plates - Bay-Tek Big Bass Wheel Service Manual

BILL ACCEPTOR DIAGNOSTICS

Note: There are many different models and brands of Bill Acceptors that are used on redemption games.
Your Bill Acceptor may differ from the unit shown. Standard DBA is MEI # AE2451-U5E Part # A5AC9091
Determine if Bill Acceptor has power:
Turn game ON—The bill acceptor should make noise as stacker cycles and
green lights on outside bezel should flash.
If NO power:
Use meter to measure 120 AC voltage at cable going into Bill Acceptor from
power strip
If power is OK:
Clean Bill Acceptor path to make sure there is nothing jamming
unit.
Check dipswitch settings on side of acceptor.
Make sure switch # 8 is OFF for Always Enable
ERROR CODES
Count the number of flashes on front bezel of Bill
Acceptor and follow on Bill Acceptor chart for
repair instructions.
BLANKING PLATES AVAILABLE
A5PL4200
A5PL9998
A5PL9097
A5PL9995
DBA Plate used for Upstacker Bill Acceptor
Plate used instead of Coin Mechanisms
Plate used for Bill Validator
Plate used instead of ticket dispenser
38