Bay-Tek Big Bass Wheel Service Manual page 36

TROUBLESHOOTING GUIDE
Problem
Spin meter never
increases.
Encoder sensor not
seeing wheel spin.
Wheel not
spinning when
player moves
handle.
Solenoid always stays on.
Players can spin wheel without
inserting money.
During attract mode- game will
make loud clicking sound.
Error shown
Shows "Power Saver Mode"
on monitor
Any other boot error.
Probable Cause
Encoder sensor dirty or faulty.
Pinched, broken, or
disconnected wiring.
I/O board faulty.
Door open
Solenoid Assy Faulty.
(Solenoid resistance is
approximately 13 ohms)
Cable problem.
AASO4150
Solenoid resistance
Solenoid
is 13 Ohms
I/O board faulty.
Solenoid Problem
Only as game starts - 12 Volts DC is present at solenoid.
TO I/O BOARD:
Phone cables are doubled up
for redundancy – Solenoid will
still work with 1 wire off
Jammed Solenoid.
Missing/Broken Springs.
Pinched Cable.
I/O board faulty.
Clean sensor and replace if needed. (AACB1901)
Inspect wiring and replace cable if needed.
(AACE1608)
Replace I/O board. (AACB1900AMP)
Wheel will not engage if game thinks door is open.
Inspect mechanism in right side door. Inspect springs
and engaging action. Replace if needed
Inspect cable from Solenoid to I/O board.
AACE160
Replace I/O board. (AACB1900AMP)
YEL-
GREE
RE
BLAC
Inspect solenoid. Ensure it operates smoothly.
Look for missing springs. Replace Assembly if
needed. (AASO4150)
Inspect phone cables for smashed cable.
May also have to replace I/O Board.
Replace I/O board. (AACB1900AMP)
Power supply may be faulty. Replace power supply.
Part # AACE1625
Replace USB Software stick drive. Part # A5FHD005
36
Remedy
.(AASO4150)
LOW
AACB1900AMP
COIN
BILL AC-
TICK-
I/O Aux Board
DOOR
CEPTOR
RED
Solenoid
BLAC
Solenoid resistance
is 13 Ohms