Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
Problem
Motor will not
assist the slow
spin.
Game should always try
to assist a slow spin.
It helps the smaller child
play the game.
Attract Mode – The big
spinning wheel attracts
players to game.
If not, the reason can
be any one of these
problems making game
go to "Abandon Game"
Brake assembly very loose or broken.
Solenoid Assy. on right side of wheel
is broken or faulty so player can spin
Wheel always
wheel anytime.
spinning.
Spin motor receiving 12 Volts DC all
the time. Spin meter screen stays on.
Spin Meter does not increase.
Stays on auto spin.
Probable Cause
Enter menu, ensure this is not
set to "Abandon Game".
Enter menu, check diagnostic
information for "motor watchdog
error"
Door open
Faulty encoder sensor.
Auto-spin
catch broken.
Drive chain broken.
Cable problem.
I/O board faulty.
Game is set to "New Jersey"
mode.
Faulty Motor
-
Replace Motor (AAMO4100)
As motor starts, 5 Volts DC is present at connector. (It builds to 12 Volts as
wheel gains speed)
TO I/O BOARD:
Phone cables are doubled
up for redundancy – Motor
will still work with 1 wire off
Change to "Motor Assist" , then power game off
and then back on.
Change "abandon game" to "Motor Assist".
Turn game off, and then back on to clear error.
Enter menu to verify change.
Motor assist will not engage if game thinks
door is open. Close all doors.
Assist motor will try for 2 seconds, not "see" the
wheel turning, and then deactivate
encoder sensor. (AACB1901)
Inspect mechanism on left side door. Replace
spring if needed
Inspect drive chain that powers wheel. Replace
if needed. (A5CH1003)
Inspect cable from Assist Motor to I/O board.
Replace I/O board. (AACB1900AMP)
New Jersey law does not allow wheel to auto-
spin.
YEL-
GREE
RE
BLAC
See "Brake Adjustment" section.
Solenoid should only engage when game is coined
up. Refer to "Wheel Engaging Solenoid"
Faulty I/O Board. Replace AACB1900AMP
Faulty encoder sensor. It does not see wheel
spinning. Refer to Encoder Sensor section.
35
Remedy
Replace
.
.(A5SREX040)
RED
MOTOR
BLAC
Motor resistance is
2-5 Ohms
Advertisement
Table of Contents
