Bay-Tek Big Bass Wheel Service Manual page 37

TROUBLESHOOTING GUIDE
Problem
Meters do not work.
Game counter clicks at start
of each game.
Ticket counter clicks as
tickets come out of game.
Monitor shows "Out of
Order Door Open "
Motor Watchdog Error
Probable Cause
The 2 crimped wires may be
faulty
Pinched, broken, or
disconnected wiring
I/O Aux Board faulty.
One or more doors open.
Faulty door switch
I/O Serial Cable unplugged.
I/O board faulty.
Encoder Sensor Faulty.
Motor Faulty.
After problem is found and fixed:
1.) Enter menu and ensure Player Timeout
option is set to "Motor Assist"
2.) Turn game off, then back on,
enter menu and again ensure Player
Timeout option is set to "Motor Assist"
3.) Verify Motor Watchdog Error is not present.
4.) Coin game, but do not spin wheel. Let game try to spin wheel own it's own.
Inspect crimps on AACO1000 to ensure good
connection.
Check connections from counters to main board.
Check continuity on wires.(AACO1000)
Replace I/O board. (AACB1900AMP)
Refer to Door Open Section below.
Replace door switch. (A5SW7000)
Inspect and re-seat serial cable from
motherboard to I/O board.
Replace I/O board. (AACB1900AMP)
Clean Encoder sensor
on left side of wheel.
Refer to "Motor will not assist a slow spin" section
above.
37
Remedy